Dynam 3.0mm Dia 90 Degree Metal E-Retract V2
Dynam 90 Degree Electronic Retract with Metal Trunion and 3.0mm Diameter Landing Gear Strut Receptacle V2 - DY-1148
Specifically used for Dynam airplanes with electronic retractable gear. This is the V2 upgrade.
- Mounting plate width: 35.1mm
- Mounting plate length: 32.8mm
- Mounting hole distance - Width: 28m
- Mounting hole distance - Length: 24.5mm
- Length: 66.2mm
- Width (Excluding mounting plate): 18mm
- Height (With mounting plate): 25.6mm
Product Questions & AnswersNOTE: Questions submitted on this page are answered by customers who have previously purchased this item. If you have a support related question that requires immediate assistance, please visit our Help Center.
Recently Viewed Products
Doesnt work all the time
On my first flight, it took me 6 attempts to make them come down. I made sure nothing was blocking it and still same issue. I even took them out of the wing and sometimes the motor just doesnt want to work. I thought it could have been the connection or the receiver but other retracts work just fine. Very upset with this purchase.
Dynam 3.0 retract v2
This item was sent to me because one of the two that I purchased had alot of Freeplay in it and I do appreciate the fact that motion did that but I'm sorry to say that the replacement retract is just as bad as the one it replaced,it too has an excessive amount of freeplay when extended,only one out of three is correct which seems to be a dynam trademark because the two that came with the plane did not work at all and overall the plane has turned into a long project just correcting all of it's flaws so if this fw190 is a typical example of dynams quality I will not be purchasing anymore of their products,I did not purchase the plane from motion rc so it's quality bears no reflexion on motion but I have been purchasing all of the parts to fix it from motion,compared to freewing,flightline or even fms dynam needs to get with the program and up their game or at least get some kind of quality control in place,this plane seems to be a collection of parts taken from the factory seconds and thirds bins just thrown in a surprise box and shipped
Had 2 flights with it and so far it is working flawlessly. Had one hard landing and no issue what so ever. Installation was a breeze using a 1.5mm set screw.
Used this on my Dynam FW-190 works great had to mode it only a little. This will work if you drill out the shaft from 3.0 to 3.6. I drilled out the shaft to 3.6 to fit. It was easy to drill because the metal is aluminum. I also had to shorten the landing gear shaft 1/8 inch or so for the perfect fit. other then these two modifications everything went smooth easy replacement. the old E-Retract had a short were the wire went into the retract do to me removing retract multiple times working on landing gear.
Retracts are very weak. Bend
Retracts are very weak. Bend easily
They function great and seem much tougher than the originals.
Thanks guys good product fast delivery