Dynam Smart Aerobatic Trainer 1500mm (59") Wingspan - PNP
Dynam Smart Pattern and Aerobatic Trainer 1500mm (59") Wingspan - PNP - DY8962PNP
The Dynam Smart trainer was designed from the ground up with the intention of creating a plane with forgiving flight manners while providing a pilot with prominent trainer airborne characteristics. Dynam focused on a design following the principle of form following function and the end result is a funky good looking plane. The entire plane is constructed from EPO foam for durability and light weight. A semi symmetrical fuselage inspired from pattern ships make this plane agile and responsive. Semi symmetrical wings with anti stall aids designed into the wing tips inspire confidence when performing slow maneuvers. This plane is a real pleasure to fly with its delightful and forgiving traits.
The tricycle undercarriage and steering nose wheel make taxing and landing merciful and enjoyable. An ample sized battery compartment will easily accommodate a wide range of 4S batteries providing greater flexibility and flight duration. Mini sized 17gram servos delegate the control surfaces with authority. For its stretched wing span of almost 60" and a 51" fuselage length, the plane is surprisingly lightweight for its size. The powerful Detrum 600Kv Brushless Outrunner motor provides enough power to do vertical climbs and bail you out of a sketchy or failed maneuver. If you should want to stand out from the crowd and truly progress and hone your flying skills the Dynam Smart Trainer is definitely the ticket.
This receiver-ready (PNP) Dynam Smart Trainer comes with the essential electronics installed. The motor, esc, and servos are pre-installed from the factory. A minimum 4 channel radio system is required for flight. A 4S LiPo battery and Li-Po charger is required to power the plane. Minimum assembly of the plane is also required along with trim and control surface adjustments to ready the plane for flight.
- Lightweight, aerobatic airframe plus sporty decal trim sheet
- Powerful BM3720A-KV600 Brushless Outrunner motor
- Anti-stall aids built in to wings for increased confidence in slow flight
- Dynam Smart Trainer 1500mm (59") Wingspan - Receiver Ready - (PNP)
- Tomcat ESC with XT-60 connector, servos and motor come pre-installed for your convenience
- Decal set
- 4 Channel Radio - Select a minimum 4 channel radio from our Radio Collection
- 4 Channel Receiver - Select a minimum 4 channel receiver from our Receiver Collection
- 4 Cell 14.8V 2200 mAh LiPo Battery with XT-60 connector - EPR22004X6
- 4 Cell Compatible Battery Charger - Select a minimum 4 cell (4S) charger from our Charger Collection
1500mm / 59in
1300mm / 51.2in
1800g / 63.6oz
|CG (Center of Gravity)||N/A|
BM3720A-KV600 Brushless Outrunner Motor
Electronic Speed Control
Tomcat 40A Brushless with XT-60 connector
Propeller / EDF
|Landing Gear||Tri-gear Fixed|
4S 14.8V 2200mAh LiPo with XT-60 connector (required)
4 Channel (required)
|Build Time||2 Hours|
Product Spare Parts
Product Questions & AnswersNOTE: Questions submitted on this page are answered by customers who have previously purchased this item. If you have a support related question that requires immediate assistance, please visit our Help Center.
Dunno what to expect
This is my Smart number two, why because I was silly. My first one flew. Not well, but it flew. I got the itch to try it again. I bought a second one and built it. After deciphering the instructions, I struggled to get it built. Following their "instructions" I built the aircraft. Until it came to joining the wings to the fuselage. The retainers had NOT been installed. There was nowhere in the instructions that told you to install them. I got frustrated but managed to work and CA them in place. Happy that I could continue I did so. But then...they were about 1 inch to short. I was stumped. I couldn't secure the wings. No way. I got frustrated again and resorted to my cure all. I CA'ed the wings on. I had the spar tube installed and then mated the wings to the fuselage. I went ahead and glued the wings to the short retainers for the added strength. I finally got the wings attached, but they are just not removable. I don't know ow they will hold, but after my first loop I will know Obviously Dynum does NOT believe in quality control. Because of this, there won't be a third Smart, but maybe I will be Smarter. Buyer beware!!!
Elevator Servo stripped out.
Shipped well to me. The elevator and tail and rudder were warp very twisted. Heat gun and work fix that. On fourth landing front landing gear fell off! No glue at all. Easy fix. But the front landing gear horn broke. Would like a new front landing gear horn to make up the $20.00 for the elevator servo. The plane flies good and lands good. I understand made in China.
Some room for improvement
I've read about problems with the Aileron Servos. I had 1 fail too. I think that the foam hinge is too stiff for the servos. I worked them by hand to loosen them up a bit, when I was replacing the servos, but I think that proper hinges are the way forward. The steering arm is a bit of a weak point too. I've not flown it much yet, due to radio failure and the weather.
I know this is a great plane because I've had several. This one came with bad motor , sounds, smoke, crash, 1st flight.
Smart Trainer Great Buy
I received the plane promptly with no damage, no warped surfaces. Packaging was real good . I was surprised at how large it was. Assembly was simple all I needed to do was drop some thread through the wing socket down to the battery compartment to pull the aileron splitter to the corresponding wing. Fly's great on 2200 ,3000. I also use a parallel connection and put two 2200 's in for a 4400 . Having lots of fun. Love the way it lands.
never got out of the garage.
worst instructions I've ever seen, so frustrating I had to put it back in the box. The "strut" that is supposed to join the two sides of the stab and be glued in was about 1/2 inch too short to fit, so I doubt this will see the light of day anytime soon.
worst instructions I've ever seen
worst instructions I've ever seen I would have liked to see the decals already on the plane I'm 71 years old and I'm not too sturdy
This is a really SMART looking plane. It does everything it's great...
Nice easy plane to fly. Taking off and landings are a breeze. Landing gear mods are a must