Freewing 80/90mm EDF Nose Landing Gear Connecting Pin
80/90mm EDF Nose Landing Gear Connecting Pin from Freewing - FJ31111087
Fits the following Freewing/FlightLine RC aircraft:
- Freewing F/A-18C Hornet
- Freewing 90mm F-22 Raptor
- Freewing F-4D Phantom II
- Freewing 80mm A-10
- FlightLine RC F7F
Product Questions & AnswersNOTE: Questions submitted on this page are answered by customers who have previously purchased this item. If you have a support related question that requires immediate assistance, please visit our Help Center.
Nose gear connecting pin
My landings, every once in awhile, are ****. I fly off grass and that contributes to the problem. My previous nose pins have broken, not bent, but sheared, and this replacement seems to be of a better material. We'll see. The retract mechanism has to be disassembled to install the new pin.
Connecting pin for nose retract
These pins are of lowest quality and snap with smallest pressure. Freezing makes good products and I wish they would address this issue.
Works As Advertised
Replaced the broken connecting pin on the Freewing F4. Replacement pin works well.
connecting pin for nose landing gear
these pins, I found to be the easiest pin to change, I really like how they are flat at the top so they don't fall through instead of using that tiny e clip to hold them in
Prima passende pin. Snel geleverd. Dus top. Jammer dat de verzendkosten voor zoiets klein nogal fors zijn.
Landing gear part
Fit perfectly. Short waiting time
F-7F Replacement Pin Seems an Improvement
After snapping two nose gear landing pins (the original and the pin in a replacement retract that fried on me) on my F-7F at the point the pin exits the trunion, I was pleasantly surprised to see the part sold as a stand-alone, and ordered several (not trusting myself). Out of the package the pin seems to be made of a different metal than the original pins were. So far it has stood up very handsomely to the ordinary stresses of having to support that long, spindly nose gear strut on the F-7F, which must put significant torque on the pin, exactly at the point where the first two failed.
A 10 nose gear connecting pin
I snapped this pin just after four flights. After reading reviews i made pin out of Trex 450 pro DFC main shaft. It is perfect, strong and after too hard landing it bend not brake.
F7F nosegear landing pin
Original item snapped on first landing on short grass. The broken part looked like it was a cast white metal item. Bought three replacements, fitted the first on and it snapped first landing again. I’ve been flying rc planes for over 20 years, and am an instructor, so am capable of landing various models. These pins look brittle, I’m now sourcing hardened steel pins, for example motor shafts, with a circlip groove on the end to allow steering.