Admiral RX600SP Support Page
Product Manuals:
Product Updates:
- January 28, 2019 - Disregard the notice in the Quick Start Guide above concering placing this unit inverted. The Admiral RX600SP will NOT work inverted. This device is meant to be mounted right side up only.
- August 17, 2018 - If you have been experiencing setup issues with the Admiral RX600SP the following is advice that should be of help: To calibrate the gyro sensor, please put the stabilizer PLUS on the table and power it on (absolutely still, no people jumping around, no wire movement…etc. slight vibration will cause gyro calibration failure indicated by the red LED flashes twice). The gyro will calibrate automatically at the time when power is provided. Within 2 seconds you should see the LED flashes twice. Green flashes twice means calibration is OK while red flashes twice means calibration failed due to movement.
- June 1, 2018 - This receiver has no port for a satellite as that section of the receiver has the mode button in it's place.
- January 18, 2018 - The most common installation has the Stabilizer Plus upright in the aircraft (i.e. on a surface that is horizontal when the model is in normal level flight attitude). The long axis of the unit must be aligned with the flight direction and the servo connectors should be to the rear of the aircraft. Also, if you have a 7+ channel radio, you can use the BIND/AUX2 port as a fully functional 7th channel with the gyro on or off.
If you need any additional assistance, please visit the Motion RC Help Center