Dubro Kwik Grip 10mm / 0.39" E/Z Connectors (2 Pack)
Kwik Grip 10mm / 0.39" E/Z Connector set by Dubro - 608
EZ Connectors link a pushrod to a servo arm allowing it to pivot for less bind in control surfaces.
- Works on 2-56 and smaller wire (.078")
- Permanent or snap on mounting push nuts both included
- Two brass Kwik Grip EZ Connectors
- Two plastic snap nuts
- Two metal snap nuts
- Two 4-40 x 3/16 Socket Head Cap Screws
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Length of Connector
10mm / 0.39in
Diameter of Connector
5.5mm / 0.21in
Two 4-40 x 3/16" socket head cap
Product Questions & AnswersNOTE: Questions submitted on this page are answered by customers who have previously purchased this item. If you have a support related question that requires immediate assistance, please visit our Help Center.
I like the pin and holder, they also look very good.
As far as I am concerned these are one of the greatest things since sliced bread. They provide a point for quick, easy, precise control linkage adjustment, and virtually eliminate the need for a threaded-on clevis at the control surface end of the linkage. I like using these instead of z-bends in the wire to connect to servo control arms.