Freewing Electronic Retract with 4.1mm Shaft Type B
Electronic Retract with 4.1mm Shaft Type B
- Body material: plastic
- Trunion material: metal
- Strut diameter: rotating shaft pin is 4.1mm in diameter
This retract is used on the nose gear of the following Freewing aircraft:
- 90mm F-104
- 90mm Stinger 90
- Eurofighter Version 2
- Super Scorpion
- F-18 Version 2
Product Questions & AnswersNOTE: Questions submitted on this page are answered by customers who have previously purchased this item. If you have a support related question that requires immediate assistance, please visit our Help Center.
very good thank you
freewing electronic retrack
This was for replacement of faulty nose gear on SU-35 just purchased, Solved problem no fault of Motion RC. Thanks Mike
This retract fits both the Stinger 90 and the T45. I have both planes and have had problems with the nosegay which is type B. On the Stinger the gear wouldn’t come down on at least 2 occasions which resulted in a skid in landing and torn off gear doors. On the T45 I’ve had 2 occasions that the gear only went up halfway or not at all. I can’t figure out what’s causing this problem whether it’s a defective retract or a voltage problem since they all work fine on the bench then once in the air under a load they quit working. Overall I’m not satisfied with these units.
Ok, needs flat surface on both sides of shaft
It works fine. But it has a flat surface for grub screw secure site on one side of shaft only. Both sides of the shaft need flat surface areas for attaching the gear parts by grub screws.
Venom replacement noseleg
Great product. Swapped straight in to place. Great service and delivery times.
Replaced the front retract on my Stinger 90. Easy job and the new one works perfectly.
Freewing elec retract type B
Purchased to replace F-86 nose gear retract. It is stronger than the one it replaced. The drive screw is larger. Lots of surgery required to install it. So far holding up well.